Save a document
A document saves by itself as you write; see what the page bar shows while it saves and what to do when a save fails.
Changes save automatically. The page bar reads Saving…, then Saved, or Save failed with a message saying what went wrong.
Wait for Saved before closing after a large edit, or save at once with Ctrl/⌘ S or Edit → Save now.
Read only means you can open the document but not change it.
When a save fails
If a save fails because the connection dropped or Magpie did not answer, the document is saved again by itself: after a few seconds, then less often, and at once when the connection is back. Keep the page open until it reads Saved.
If the document's link is set to Can view or turned off, or the document is moved or put in Trash while you write in it, the page stops saving and says so. Select Copy text to keep what you wrote since the last save.
If a document will not save, copy any unsaved writing somewhere safe before reloading, then Contact support.
Ask Magpie support
Send Magpie staff a question about anything this article does not answer.