Open this in Magpie

When a run fails after the automation last worked, the automation is marked Needs attention on its row and in the editor's bar. It stays on, and the row says why the latest run failed. The next run that works clears the mark.

Run again from the failed step

  1. Open the failed run from Runs, or from the link in the email about it.
  2. Read the failed step's reason, and put right what it names. For example, restore the spreadsheet from Trash.
  3. Choose Run again from the failed step.

The run does the failed step and the steps after it. It never does again a step that was already done.

A step that may have happened

A step is marked May have happened, and the run fails, in two cases:

  • Magpie stopped while the step was being done.
  • Something went wrong inside the step while it was being done.

Magpie never does that step again by itself.

Run again from the failed step then asks you to check first, such as whether the contact or the row is already there. Run it again only if the step did not happen.

Steps Magpie tries again

Some failures can pass by themselves, and the step says so: a web address that did not answer, someone changing the spreadsheet at the same moment, the email service not taking an email. The run shows Trying again soon, and Magpie tries the step again after 1 minute, 5 minutes, 30 minutes and 2 hours. If it still fails, the run fails.

Other failures happen again however often they are tried, such as a record in Trash or a step the member it runs with is not allowed to do. Those fail the run at once.

A paused automation

An automation whose runs have all failed for 7 days, with at least 10 failed runs, is paused. While it is paused, each time its When happens Magpie keeps a held run that does nothing yet, up to 1,000 held runs. A held run is discarded after 14 days.

  1. Put right what made the runs fail.
  2. Open the automation and choose Turn on.
  3. Choose Turn on and run them to do the held runs now with your access, or Turn on and discard them.

Held runs count toward the month's runs when they run. If the month's runs are used before all of them have run, the rest are discarded.

Turn off on a paused automation that holds runs asks first, because turning it off discards them. Choose Turn off and discard them to go on.

Take over an automation

An automation is also paused when the member it runs with can no longer run it: they left the team, closed their account, can only view the team, or can no longer use an area the automation works in. Magpie pauses it the next time it would run, and the team's admins get one email.

  1. Open the automation. The bar says who can no longer run it.
  2. Choose Take over and turn on. Magpie checks every step against your access.
  3. If the automation holds runs, choose Take over and run them or Take over and discard them.

From then on the automation runs with your access. Any member with edit access can take it over.

Emails about automations

  • A run failed after the automation last worked: the member it runs with. Turn this off in Automations settings with Email me when an automation fails.
  • An automation was paused because its runs kept failing: the member it runs with and the team's admins.
  • Automations were paused because the member they run with can no longer run them: the team's admins, in one email.
  • This month's runs are used: the team's admins, or you in Personal, once a month.

If an automation still fails after these steps, Contact support.

Ask Magpie support

Send Magpie staff a question about anything this article does not answer.